Accelerometers

Individual calibration
All PLACID accelerometers are being calibrated in a controlled laboratory environment using traceable calibration equipment complying with ISO17025 standards.
We recommend that all PLACID accelerometers are re-calibrated every year to guarantee an optimized usage.
PLACID Traceable Calibration is performed by our qualified staff and under controlled conditions according to the procedures and standards such as ISO17025.

Quality
All PLACID accelerometers are made of high-quality materials that will ensure long stability and durability, even in harsh condition. PLACID offers 2 years warranty against defective materials and workmanship.
All our accelerometers are made from Stainless steel.

PLACID Accelerometer PQV 1050

The PLACID PQV 1050 is used for all forthcoming vibration measurements where only a 1-axis signal is required.

PLACID Accelerometer PQV 3010

The PLACID PQV 3010is an IEPE powered accelerometer. As the output impedance of our IEPE accelerometers is between 100-300 Ohm, no special low-noise cable is required.

PLACID Accelerometer PQV 3050

The PLACID PQV 3050 is an IEPE powered accelerometer. As the output impedance of our IEPE accelerometers is between 100-300 Ohm, no special low-noise cable is required.

PLACID Accelerometer PQV 1050-4

The PLACID PQV 1050-4 is used for all forthcoming vibration measurements where only a 1-axis signal is required.

PLACID Accelerometer PQV 3500

The PLACID PQV 3500 is an IEPE powered accelerometer. As the output impedance of our IEPE accelerometers is between 100-300 Ohm, no special low-noise cable is required.

Thailand